Operation Manual

INSERTING THE BOBBIN

When inserting or removing the bobbin, the needle must be

fully raised.

- Open the hinged cover. (1)

- Hold the bobbin case with one hand. Insert the bobbin so

that the bobbin runs in a clockwise direction (arrow). (2)

- Pull the thread through the slot, down and to the left until

it enters the delivery eyelet (rectangular opening) under

the tension spring. (3)

- Hold the bobbin case by the hinged latch. (4)

- Insert the bobbin case fully into the shuttle race and

release the latch. Make sure that the metal ¿ nger ¿ ts into

the notch at the top of the race cover. (5) Push on the

bobbin case to be sure it is clicked in completely.

Attention: Turn power switch to “O” before inserting or

removing the bobbin.