56 030 OWNER’S MANUAL Model Number H354SG Product No. 960 73 00-03 54 Inch Mower Grass Catcher • • • • 532411285 12.15.06 BY Assembly Operation Customer Responsibilities Repair Parts Printed in U.S.A.
SAFETY RULES Safe Operation Practices for Ride-On Mowers IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • WARNING: In order to prevent accidental starting when setting up, transporting, adjusting or making repairs, always disconnect spark plug wire and place wire where it cannot contact spark plug.
SAFETY RULES Safe Operation Practices for Ride-On Mowers IV. TOWING • • • • • • Tow only with a machine that has a hitch designed for towing. Do not attach towed equipment except at the hitch point. Follow the manufacturer's recommendation for weight limits for towed equipment and towing on slopes. Never allow children or others in or on towed equipment. On slopes, the weight of the towed equipment may cause loss of traction and loss of control. Travel slowly and allow extra distance to stop.
KNOW YOUR GRASS CATCHER READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE ASSEMBLING OR OPERATING YOUR GRASS CATCHER. Compare the illustrations with the carton contents to familiarize yourself with the parts before starting the assembly. Study the operating instructions and safety precautions thoroughly to insure proper functioning of your Grass Catcher and to prevent injury to yourself and others. Save this manual for future reference.
ASSEMBLY 1 2 HANG SUPPORT ASSEMBLY ON REAR DRAWBAR (See Fig. 1) MOUNTING COVER ASSEMBLY TO SUPPORT ASSEMBLY (See Fig. 2) NOTE: For ease of assembly, you may wish to obtain the assistance of another person for mounting cover assembly to tractor. 1. Position cover assembly on ground behind tractor. 2. Lift and rotate cover to align cover brackets with support assembly tubes. 3. Slide cover assembly down onto the support tubes. 1.
3 4 CONTAINER MOUNTING (See Fig. 3) LOWER CHUTE (See Fig. 4) 1. Raise and hold deflector shield in upright position. 2. Place slot in lower chute over mounting tab on mower and position lower chute over mower opening as shown. 3. Hook rear latch into flange hole on back of mower. 4. Hook front latch into hole in front gauge wheel bracket or under gauge wheel bracket on mower without a hole in the bracket. 1. Install one container to left side first.
5 6 UPPER CHUTE (See Figs. 5A and 5B) 1. Lower mower to its lowest cutting position. 2. Assemble upper chute by inserting curved end into hole in back of cover. TIP: Holding upper chute as shown and twisting while installing in cover will help keep the rubber seal in place. NOTE: Handle carefully so as not to damage full bag indicator. COVER Be sure deck is properly leveled for best mower performance. See your tractors owner's manual for instructions. UPPER CHUTE FIG. 5A 3.
OPERATION TIPS FOR IMPROVED BAGGING OPERATION: • Your bagger is equipped with a full bagger indicator. Movement of the wheel increases as the bags fill. The wheel will be spinning fastest just before the bags fill completely. When the wheel stops, it indicates that the bags are full and the chutes have become clogged. NOTE: To help prevent clogging of chutes, check/empty bags when the wheel is spinning fast. Experience will teach you the best time to empty the bags.
CUSTOMER RESPONSIBILITIES GENERAL RECOMMENDATIONS CAUTION: Grass catcher components are subject to wear, damage and deterioration, which could expose moving parts or allow objects to be thrown. Frequently check components and replace with manufacturer's recommended parts, when necessary. Always observe safety rules when performing any maintenance. • Before each use check for loose fasteners. • Clean unit thoroughly after each use. BLADE CARE For best results mower blades must be kept sharp.
REPAIR PARTS GRASS CATCHER - MODEL NUMBER H354SG (PRODUCT NO. 960 73 00-03) 5 6 4 7 3 8 20 10 9 18 11 20 2 2 15 20 38 9 38 12 13 14 20 34 15 33 9 12 37 26 14 32 31 33 31 27 35 30 KEY NO. 2 3 4 5 6 7 8 9 10 11 12 13 14 15 PART NO.