Specifications

Issued by: Therese Berg

Issued date: 200421

3 (8)

4.1 Robotic mower

The ZASHQBLE-1A, -1B and -1C designs are certified as limited modular approvals due

to the design without shielded RF-circuit. Therefore shall the radio characteristics be

verified on the robotic lawn mower. This check can be done as a spot check with the

mower in a typical configuration to verify fundamental frequency and spurious emissions

according to applicable rules as mentioned above.

The ZASHQBLE-1A, -1B and -1C are only FCC authorized for the rules mentioned

above. The robotic lawn mower must comply to all applicable FCC rules, including Part

15B for unintentional radiators with applicable radio transmitters included.

4.1.1 Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with minimum distance

20 cm between the radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other

antenna or transmitter.

Canada

This equipment complies with Canada radiation exposure limits set forth for an

uncontrolled environment. This equipment should be installed and operated with

minimum distance 20 cm between the radiator & your body.

Déclaration d'exposition aux radiations

Cet équipement est conforme Canada limites d'exposition aux radiations dans un

environnement non contrôlé. Cet équipement doit être installé et utilisé à distance

minimum de 20 cm entre le radiateur et votre corps.

4.1.2 FCC ID label

If boards with Bluetooth functionality are mounted so that the FCC ID cannot be seen

from the outside, the robotic mower shall be marked with a label with the FCC ID. The

label should be seen from the outside of the mower and easy for the customer to find.

The following format is recommended on the label:

This device contains module FCC ID XXXXXXX

Where XXXXXXX shall be exchanged to the applicable FCC ID, i.e according to Table 1

and Table 2 above, for instance “This device contains module FCC ID ZASHQ-BLE-1A”.

Also the Canadian IC should be mentioned for mowers intended for Canada. The

recommended format is then the following:

This device contains module FCC ID XXXXXXX IC:YYYYYYYY

Where XXXXXXX and YYYYYYYY shall be exchanged to the applicable FCC ID and IC

ID, i.e according to Table 1 and Table 2 above, for instance “This device contains module

FCC ID ZASHQ-BLE-1A IC: 23307-HQBLE1A”.