Operator's Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- To attach the handle
- To assemble the handlebar
- To put the handlebar in transport position
- To assemble the cutting equipment
- Cutting equipment and guards
- To adjust the Balance XB harness (535iRXT)
- To adjust the harness (535iFR, 535iRX)
- Operation
- Introduction
- Husqvarna Connect
- To start to use Husqvarna Connect
- To connect the battery to the product
- Work position
- Correct balance of the product
- To apply the load equally on the shoulders
- Before you operate the product
- To start the product
- To limit the maximum speed with the mode button
- To extend the trimmer line with the ErgoFeed function (535iRXT)
- Automatic shutdown function
- Blade thrust
- General work instructions
- Forestry clearing with a saw blade
- Brush cutting with a saw blade
- To clear grass with a grass blade
- Grass trimming with a trimmer head
- To stop the product
- Maintenance
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Accessories
2. Attach the saw blade guard (E) with 4 bolts (F) in the
holder (A).
B
C
D
F
A
E
To remove the saw blade guard (535iFR)
1. Remove the 4 bolts (L) from the holder (R) and
remove the saw blade guard (A).
H
J
K
L
R
A
2. Remove the 2 bolts (J) on the gear housing
(K).Remove the holder (R) and the bracket (H).
To attach the saw blade (535iFR)
1. Put the drive disc (A) on the output shaft.
2. Turn the output shaft to align one of the holes in the
drive disc with the related hole in the gear housing.
3. Put the locking pin (B) in the hole to lock the shaft.
4. Put the saw blade (C) and the support flange (D) on
the output shaft.
D
E
C
A
B
5. Make sure that the drive disc and support flange
engages correctly in the center hole of the grass
blade.
6. Attach the nut (E).
7. Tighten the nut with the socket wrench. Hold the
shaft of the socket wrench near the blade guard.
Tighten in the opposite direction to how the cutting
attachment rotates. Tighten it to a torque of 35-50
Nm.
To remove the saw blade (535iFR)
1. Put the locking pin (C) into the hole to lock the shaft.
2. Remove the nut the nut (G).
3. Remove the support flange (F) and the saw blade
(D) from the output shaft.
F
G
D
B
C
4. Remove the drive disc (B) from the output shaft.
To adjust the Balance XB harness
(535iRXT)
1. Put the harness on.
16
609 - 001 -