Operator's Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- To attach the handle
- To assemble the handlebar
- To put the handlebar in transport position
- To assemble the cutting equipment
- Cutting equipment and guards
- To adjust the Balance XB harness (535iRXT)
- To adjust the harness (535iFR, 535iRX)
- Operation
- Introduction
- Husqvarna Connect
- To start to use Husqvarna Connect
- To connect the battery to the product
- Work position
- Correct balance of the product
- To apply the load equally on the shoulders
- Before you operate the product
- To start the product
- To limit the maximum speed with the mode button
- To extend the trimmer line with the ErgoFeed function (535iRXT)
- Automatic shutdown function
- Blade thrust
- General work instructions
- Forestry clearing with a saw blade
- Brush cutting with a saw blade
- To clear grass with a grass blade
- Grass trimming with a trimmer head
- To stop the product
- Maintenance
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Accessories
2. Push the 2 parts of the breastplate together as
shown in the illustration.
3. Tighten the hip strap tightly. Make sure that the hip
strap aligns with the hip.
4. Tighten the chest strap below your left arm tightly.
The chest strap must be tight against your body.
5. Adjust the shoulder strap until the weight is equal on
the 2 shoulders.
6. Adjust the height of the suspension point. For
forestry clearing, the correct height of the
suspension is approximately 10 cm below your hip.
Refer to
Correct balance of the product on page 19
.
7. Attach the battery carrier to the harness.
Note: It is possible to attach 1 extra battery to the
battery carrier. The battery carrier is available as an
accessory.
8. Attach a battery.
To adjust the harness (535iFR,
535iRX)
WARNING:
Always attach this product to the
harness correctly. If not, you cannot control
the product safely and this can result in
injury to you or others. Do not use a harness
with a defective quick release.
WARNING: Use the harness quick release
function if you must release from the product
and the harness in an emergency situation.
1. Put on the harness.
2. Adjust the harness for the best work position.
609 - 001 -
17