Operator's Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- To attach the handle
- To assemble the handlebar
- To put the handlebar in transport position
- To assemble the cutting equipment
- Cutting equipment and guards
- To adjust the Balance XB harness (535iRXT)
- To adjust the harness (535iFR, 535iRX)
- Operation
- Introduction
- Husqvarna Connect
- To start to use Husqvarna Connect
- To connect the battery to the product
- Work position
- Correct balance of the product
- To apply the load equally on the shoulders
- Before you operate the product
- To start the product
- To limit the maximum speed with the mode button
- To extend the trimmer line with the ErgoFeed function (535iRXT)
- Automatic shutdown function
- Blade thrust
- General work instructions
- Forestry clearing with a saw blade
- Brush cutting with a saw blade
- To clear grass with a grass blade
- Grass trimming with a trimmer head
- To stop the product
- Maintenance
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Accessories
To fell a tree to the right
To fell to the right, push the bottom of the tree to the left.
1. Apply full throttle.
2. Put the saw blade against the tree as given in the
picture.
3. Tilt the saw blade and push it with force diagonally
up and to the right. At the same time, push the tree
with the blade guard.
To fell a tree forward
To fell forward, push the bottom of the tree rearward.
1. Apply full throttle.
2. Put the saw blade against the tree as given in the
picture.
3. Pull the saw blade forward with a fast movement.
To fell large trees
Large trees must be cut from 2 sides.
1. Examine in which direction the tree will fall.
2. Apply full throttle.
3. Do the first cut on the side of the tree to which it will
fall.
4. Cut through the tree from the other side.
CAUTION: If the saw blade becomes
blocked, do not pull the product with a
sudden movement. That can cause damage
to the saw blade, bevel gear, shaft or
handlebar. Release the handles, hold the
shaft with 2 hands and carefully pull the
product.
Note: Use more cutting pressure fo fell small trees. Use
less cutting pressure to fell large trees.
Brush cutting with a saw blade
To fell to the left, push the bottom of the tree to the right.
• Cut down thin trees and brush.
• Move the product from side to side.
• Cut many trees in one movement.
22
609 - 001 -