Operator's Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- To attach the handle
- To assemble the handlebar
- To put the handlebar in transport position
- To assemble the cutting equipment
- Cutting equipment and guards
- To adjust the Balance XB harness (535iRXT)
- To adjust the harness (535iFR, 535iRX)
- Operation
- Introduction
- Husqvarna Connect
- To start to use Husqvarna Connect
- To connect the battery to the product
- Work position
- Correct balance of the product
- To apply the load equally on the shoulders
- Before you operate the product
- To start the product
- To limit the maximum speed with the mode button
- To extend the trimmer line with the ErgoFeed function (535iRXT)
- Automatic shutdown function
- Blade thrust
- General work instructions
- Forestry clearing with a saw blade
- Brush cutting with a saw blade
- To clear grass with a grass blade
- Grass trimming with a trimmer head
- To stop the product
- Maintenance
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Accessories
Bevel gear
The bevel gear is filled to ¾ with grease at the factory.
Before use, make sure that the grease level has not
changed. Use Husqvarna special grease if it is
necessary to fill up. Do not change the grease in the
bevel gear. Let servicing personnel do the repair of the
bevel gear.
Troubleshooting
User interface
LED display Possible faults Possible action
Battery LED indicator flashes or-
ange
Low battery voltage. Charge the battery.
Red error LED flashes Overload. The cutting attachment is jammed. deacti-
vate the product. Remove the battery. Clean
the cutting attachment from unwanted mate-
rials.
Temperature deviation. Let the product cool down.
The power trigger and the acti-
vate button are pressed at the
same time.
Release the power trigger and the product is
active.
The product does not start Dirt in the battery connectors. Clean the battery connectors with com-
pressed air or a soft brush.
Error LED is lit with red light The product needs servicing. Contact your servicing agent.
Transportation, storage and disposal
Transportation and storage
• The supplied Li-ion batteries obey the Dangerous
Goods Legislation requirements.
• Obey the special requirement on package and labels
for commercial transportation, including by third
parties and forwarding agents.
• Speak to a person with special training in dangerous
material before you send the product. Obey all
applicable national regulations.
• Use tape on open contacts when you put the battery
in a package. Put the battery in the package tightly
to prevent movement.
• Remove the battery for storage or transportation.
• Put the battery and the battery charger in a space
that is dry and free from moisture and frost.
• Do not keep the battery in an area where static
electricity can occur. Do not keep the battery in a
metal box.
609 - 001 - 27