Operator's Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- To attach the handle
- To assemble the handlebar
- To put the handlebar in transport position
- To assemble the cutting equipment
- Cutting equipment and guards
- To adjust the Balance XB harness (535iRXT)
- To adjust the harness (535iFR, 535iRX)
- Operation
- Introduction
- Husqvarna Connect
- To start to use Husqvarna Connect
- To connect the battery to the product
- Work position
- Correct balance of the product
- To apply the load equally on the shoulders
- Before you operate the product
- To start the product
- To limit the maximum speed with the mode button
- To extend the trimmer line with the ErgoFeed function (535iRXT)
- Automatic shutdown function
- Blade thrust
- General work instructions
- Forestry clearing with a saw blade
- Brush cutting with a saw blade
- To clear grass with a grass blade
- Grass trimming with a trimmer head
- To stop the product
- Maintenance
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Accessories
535iFR 535iRXT 535iRX
Equipped with grass blade (original), left/
right, m/s
2
2.5/2.0 2.4/2.0 2.4/2.0
Note: For comparison of vibrations levels, battery and combustion products use the vibration calculator. https://
www.husqvarna.com/uk/services-solutions/vibration-calculator/
Radio frequency data for Bluetooth
®
Frequency band, GHz 2.4-2.4835 2.4-2.4835 -
Output power, max dBm 0 0 0 -
Approved batteries
Battery
BLi300
Type Lithium-ion
Battery capacity, Ah 9.4
Nominal voltage, V 36
Weight, kg (lb) 1.9 (4.2)
Approved battery chargers
Battery charger
QC500
Input voltage, V 100-240
Frequency, Hz 50-60
Power, W 500
Accessories
Accessories
The accessories are recommended for use in
combination with the specified power heads and have
been evaluated to applicable ISO- and EN safety
requirement standards by the Swedish Machinery
Testing Institute.
The accessories used in combination with the specified
power heads have been evaluated to ANSI B175.3-2013
Grass Trimmers and Brushcutters - Safety
Requirements. These combinations have been
evaluated by Underwriters Laboratories Inc. (UL) and
are consequently UL listed.
Approved accessories Accessory type Cutting attachment guard, art. no.
Center hole in blades/knives, Ø 25.4 mm
Output shaft thread M12
609 - 001 - 29