Operators Manual

5119350-01
READ THESE INSTRUCTIONS CARE-
FULLY!
KNOW YOUR CONTROLS.
LEARN HOW TO STOP YOUR TRIM-
MER IN AN EMERGENCY
PREPARATION
Before using your new Husqvarna Hover
Trimmer, make a careful note of the details on
the serial number label, which can be found on
the rear of the deck.
Always quote these details to your dealer
when enquiring about spares and service.
NOTE:
Before transporting the machine from
one trimming area to another, close fuel
tap and let engine continue to run until it
stops (in order to empty the carburettor
bowl) then disconnect the spark plug
lead. Transport in a horizontal position.
NEVER TRANSPORT THE TRIM-
MER WHEN IT IS RUNNING.
Upper Handle
Stop/
Run/
Choke
Lever
Lower Handle
Deck
Spark
Plug/Lead
Starting
Handle
ASSEMBLY OF LOWER
HANDLE TO DECK
Fuel
Filler
Cap
Muffler
Oill Filler
Air Filter
AIR CUSHION GASOLINE TRIM-
MER
OPERATOR MANUAL
HVT52
With the trimmer on the ground:
1.Remove the pins (1) and retaining clips
(2) from the polythene bag.
2.Place the lower handle (3) into the
deck bracket (4).
3.Insert the pin (1) through deck bracket
(4) and lower handle (3).
4.Secure by inserting the retaining clip
(2) into the holes in the pin at the
angle shown.
Assemble upper handle (5) to lower
handle (6) by fitting bolts (7) and washers
(8) and securing with wing knobs (9).
ASSEMBLY OF UPPER
HANDLE TO LOWER HANDLE
1
3
4
5
6
7
9
8
The handle position can be altered by
moving it forward for the park position or
back for the trimming position.
HANDLE POSITION
TRANSPORTING THE TRIM-
MER
Trimming Position
Bolt, washer
and wing knob
Tie Wraps
2
Fuel
Ta p
YOUR HONDA ENGINE OWNERS
MANUAL COVERS TWO ENGINES.
PLEASE READ THE MANUAL TO
FULLY IDENTIFY AND USE THE FEA-
TURES THAT APPLY TO YOUR
PETROL TRIMMER
NOTE:- YOUR HUSQV
ARNA
TRIMMER DOES NOT HAVE A
FLYWHEEL BRAKE
A WHEELS KIT IS AVAILABLE FOR
THE HVT52 TRIMMER.
ASK YOUR SERVICE DEALER FOR
DETAILS.

Summary of content (4 pages)