Operation Manual

14
Functions and InfoDisplay
Reverse
REVERSE is touched to sew in
reverse. When the button is
released, Interlude sews forwards.
The longest reverse stitch length is
3 mm.
For permanent reverse, touch the
button twice in quick succession
before starting to sew. The reverse
sewing is indicated by an icon on
the InfoDisplay.
Interlude sews in reverse until you
touch the button again.
Stitch length
When you select a stitch, your
Interlude automatically sets the
best stitch length. The set length is
visible on the InfoDisplay above
the stitch length buttons. You can
change the stitch length by touching
either the (+) or (-) button.
Stitch width
The stitch width is set in the same
manner as the stitch length. The set
width is visible on the InfoDisplay
above the stitch width buttons. The
width can be adjusted between
0 and 6 mm. If straight stitch is
selected, the width button is used to
adjust the needle position.
Stop
STOP is used to conclude a stitch.
Your Interlude fastens the thread
and stops automatically when a
stitch or stitch sequence has been
completed. STOP is cancelled when
you touch the button again or by
selecting a new stitch. When STOP
is active, an icon is shown on the
InfoDisplay. The stop-function can
also be programmed.
Mirror Side to Side
Touch this button to mirror the
selected stitch side to side. If this
button is touched when straight
stitch with left needle position
is selected, the needle position
is changed from left to right. If
touched in
REP, the whole stitch
combination is mirrored (see page
22).
The Functions Panel