Operator’s manual & spare parts list.
TABLE OF CONTENTS Section Page No. Table of Contents.............................................. 2 Section Page No. Uses................................................................... 7 Contact Information.......................................... 2 Tools.................................................................. 7 Symbols............................................................. 3 Assembly...................................................... 7 - 8 Introduction..............
KEY TO SYMBOLS SAFETY SYMBOLS & DECALS Key to symbols WARNING! The machine can be a dangerous tool if used incorrectly or carelessly, which can cause serious or fatal injury to the operator or others. Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. Stop, in the fixed position. Operator must wear head protection such as a hard hat! Other symbols/decals on the machine refer to special certification requirements for certain markets.
SAFETY INSTRUCTIONS Introduction Thank you for purchasing your new machine from Husqvarna Construction Products. We have provided important safety messages in this manual and on the machine. Please read these messages carefully. A safety message alerts you to potential hazards that could hurt you or others. Each safety message is preceded by a symbol or the safety alert symbol ( ) and one of two words, WARNING, or CAUTION.
SAFETY INSTRUCTIONS WARNING! Read, understand, and follow all warnings and instructions in this and the K750 manuals. Failure to do so may result in serious personal injury as well as damage to the equipment. It is not possible to cover all possible risk situations that can arise in conjunction with pipe cutting and beveling within these instructions. Use common sense and caution at all times. Remember: “If you don’t know – don’t do.
WHAT IS WHAT WHAT IS WHAT (PARTS IDENTIFICATION) A. SpeedMill BLADE GUARD: Designed specifically for the SpeedMill. One side is open to allow mounting of the SpeedMill Bowls. Read this Operation Manual for more information. See SpeedMill Spare Parts List in this document for part number. F. 150mm (6”) SpeedMill Bowl: Designed specifically for the SpeedMill. Use for beveling 6” (150mm) plastic pipe. Read this Operation Manual for more information.
USES, TOOLS, AND ASSEMBLY Uses: Cutting and beveling of 100mm (4”), 150mm (6”), and 200mm (8”) PVC pipe of the following types; ASTM D2241 IPS Gasketed Pipe, and ASTM D3034 Gravity Sewer Pipe (Type SDR 35, and SDR 26). Note that this machine, as supplied, is not designed for cutting AWWA C900 Municipal Water Pipe, or any non-plastic material.
ASSEMBLY AND OPERATION Mount the SpeedMill Bowl Assembly. Align the slot in the SpeedMill Hub with the face of the shaft. Make sure the flange face of the SpeedMill Hub contacts the face of the blade. Install the blade shaft bolt into the Hub Assembly. OPERATION: WARNING! Before starting up machine make sure you completely read these instructions and the power cutter operation manual.
OPERATION Rotate Pipe and repeat this cutting process until pipe circumference is cut. Align proper SpeedMill Bowl with end of pipe, and move toward the pipe so that the pipe is slightly beveled. Note: The bevel required is usually quite small, so do not remove excessive pipe material. Bevel Pipe: Position SpeedMill Bowl near end of pipe to be beveled. Accelerate power cutter to full throttle.
MAINTENANCE MAINTENANCE: CONVERTING THE SPEEDMILL TO A REGULAR POWER CUTTER. CAUTION! Allow SpeedMill Bowls to cool before performing any maintenance. NOTICE! DO NOT hold SpeedMill Bowls using a screwdriver or other device through the slots in the bowl. Damage to the bowls or abrasive coating could occur. DO NOT use a screw driver or similar in the slots of the SpeedMill Bowls to lock the blade. If you do it is likely the flanges will be damages and become unusable.
SPARE PARTS SpeedMill 11
115 07 95-27 12 SpeedMill 2007-10
