Operators Manual
Table Of Contents
- Symbols on the machine:
- Symbols in the operator’s manual:
- Contents
- Steps before using a new power cutter
- Personal protective equipment
- General safety warnings
- Machine¢s safety equipment
- Cutting blades
- General working instructions
- Assembly
- Fitting the cutting blade
- Guard for the blade
- Before starting
- General
- Cleaning
- Electrical Feed
- Replacing the carbon brushes
- Bevel gear
- Checking the drive axle and flange washers
- Checking water connection with flow limiter
- Daily maintenance
- Cutting equipment
- Recommended cable dimensions
- EC-declaration of conformity
English – 3
CONTENTS
Contents
KEY TO SYMBOLS
Symbols on the machine: ............................................. 2
Symbols in the operator’s manual: ............................... 2
CONTENTS
Contents ...................................................................... 3
WHAT IS WHAT?
What is what on the power cutter - K3000? ................. 4
WHAT IS WHAT?
What is what on the power cutter - K3000 Wet? .......... 5
SAFETY INSTRUCTIONS
Steps before using a new power cutter ........................ 6
Personal protective equipment ..................................... 6
SAFETY INSTRUCTIONS
General safety warnings .............................................. 7
Machine′s safety equipment ........................................ 9
Cutting blades .............................................................. 10
General working instructions ....................................... 12
ASSEMBLY
Assembly ..................................................................... 14
Fitting the cutting blade ................................................ 14
Guard for the blade ...................................................... 14
STARTING AND STOPPING
Before starting ............................................................. 15
MAINTENANCE
General ........................................................................ 16
Cleaning ....................................................................... 16
Electrical Feed ............................................................. 16
Replacing the carbon brushes ..................................... 16
Bevel gear .................................................................... 17
Checking the drive axle and flange washers ............... 17
Checking water connection with flow limiter ................ 17
Daily maintenance ....................................................... 17
TECHNICAL DATA
Cutting equipment ........................................................ 18
Recommended cable dimensions ................................ 18
EC-declaration of conformity ........................................ 19