Operators Manual
Table Of Contents
- Symbols on the machine:
- Symbols in the operator’s manual:
- Contents
- Steps before using a new power cutter
- Personal protective equipment
- General safety warnings
- Machine¢s safety equipment
- Cutting blades
- General working instructions
- Assembly
- Fitting the cutting blade
- Guard for the blade
- Before starting
- General
- Cleaning
- Electrical Feed
- Replacing the carbon brushes
- Bevel gear
- Checking the drive axle and flange washers
- Checking water connection with flow limiter
- Daily maintenance
- Cutting equipment
- Recommended cable dimensions
- EC-declaration of conformity
English – 5
WHAT IS WHAT?
What is what on the power cutter - K3000 Wet?
1 Rear handle
2 Guard for the blade
3 Water kit
4 Cutting blade
5 Locking the axle
6 Front handle
7 Inspection covers
8 Power switch lock
9 Switch
10 Water tap
11 Water connection with flow limiter
12 Rating plate
13 Brush retainer
14 Carbon brushes
15 Ground fault circuit interrupter (not for GB)
16 Combination spanner
17 Operator′s manual