Operation Manual

ASSEMBLING AND ADJUSTMENTS
English – 23
Catcher
Assembly
Fit the catcher bag.
• Insert the catcher bag’s edging strip into the groove
around the upper cover and press on the strip to the
end.
• Fasten the three snap fasteners around the bar of the
upper cover.
• Attach the hooks in the upper edge of the chassis.
• Fit the bagger bottom in the discharge hole.
Cutting height
The cutting height can be adjusted in 10 different steps.
• Move the lever to the back for higher cutting height
and to the front for lower cutting height.
Filling with oil
• The oil tank is empty at delivery. Fill the oil slowly. See
also instructions under the Maintenance heading. The
engine oil should be changed the first time after 5
hours running time.
CAUTION! Do not set the cutting height too low as there
is a risk that the cutters might hit ground with
unevenness.