Operation Manual

MAINTENANCE
86 – English
General
• Let your Husqvarna dealer regularly check the
machine and make essential adjustments and repairs.
• Replace any damaged, worn or broken parts.
• Always use genuine accessories.
Maintenance schedule
In the maintenance schedule you can see which parts of
your machine that require maintenance, and with which
intervals it should take place. The intervals are calculated
based on daily use of the machine, and may differ
depending on the rate of usage.
*See instructions in the section "Machine’s safety
equipment".
General inspection
• Check that nuts and screws are tight.
LC353VB
Make sure the cable clip is properly secured to the
bracket. If the cable clip feels loose or have fallen of,
mount the clip back into place.
External cleaning
• Brush leaves, grass and the like off of the lawn mower.
• Do not use a high pressure washer to clean the
machine.
• Never flush water directly on the engine.
• Clean the air intake on the starter. Check the starter
and starter cord.
• When cleaning under the cutting cover, empty the fuel
tank and put the machine on its side with the muffler
down.
Cleaning of the gear housing.
• Remove the service hatch.
• Brush leaves and grass off of gear housing. If
necessary clean the gear housing with water. For
LC348Ve and LC353VE make sure the battery is
disengaged.
Oil level
The lawn mower should stand on flat ground when you
check the oil level. Check the oil level with the dipstick on
the oil filler cap.
• Remove the oil cap and wipe the dipstick clean.
• Put the dipstick back in. The oil filler cap must be
completely screwed down to give a correct picture of
the oil level.
• If the oil level is low, fill using engine oil up to the upper
level on the dipstick.
Oil change
• Empty the fuel tank.
• Unscrew the oil filler cap.
• Place a suitable vessel to collect the oil in.
• Drain the oil by tipping the engine so that the oil runs
out through the filler pipe. Ask where you can dispose
of surplus engine oil at your local petrol station.
• Fill with new engine oil of a good quality. See
instructions in the section "Technical data".
!
WARNING! The user must only carry out
the maintenance and service work
described in this Operator's Manual.
More extensive work must be carried out
by an authorized service workshop.
Switch off the engine before carrying out
any checks or maintenance. Prevent
unintentional starting by removing the
ignition cable from the spark plug. The
starter key or battery must also be
removed on machines with electric start.
The life span of the machine can be
reduced and the risk of accidents can
increase if machine maintenance is not
carried out correctly and if service and/or
repairs are not carried out professionally.
If you need further information please
contact your nearest service workshop.
Daily
maintenance
Weekly
maintenance
50 hours
At least
once a
year
General
inspection
Spark plug
Replacing
and
adjusting
the V-belt
Replacing
and
adjusting
the V-belt
Oil level Muffler* Air filter Air filter
External
cleaning
Vibration
damping
system*
Fuel
system
Fuel
system
Cutting
equipment
Oil change
Oil
change
Cutting cover
and
protective
cover*
Engine brake
handle*