Operation Manual

16
The Control Unit
The control unit is shown here. To activate the Auto Stitch Press
the Auto Stitch Button and ensure that the light under the button
is on. Now to start press the start/stop button this can be found
on either controller. As the machine is moved movement is
detected and the speed of the machine will adjust to keep the
stitch length constant. The dial on the left side is for the stitch
length adjustment. To activate the manual stitch, press the manual stitch button and ensure that the light under
the button is lit. Now press the start/stop button on either controller to start. This keeps the machine speed
constant. The dial on the right controller sets the machine speed. YOU ONLY USE ONE MODE OR THE
OTHER. The needle position sets your machine to stop with the needle up or down. For a single stitch press the
button that has a light under it lit and the machine will complete one full turn. So if the needle up is on you can
press the needle up and it will cycle and you can now pull you bobbin thread to the top.
Left controller with Auto Stitch Right controller with needle
(stitch regulation) and Manual up and needle down. Knob
Stitch Knob adjust stitches per adjust speed when in manual
Inch in Auto Stitch. Stitch.
Both controllers have a start stop button.