Operation Manual

27
Turn the hand wheel to locate the needle at it’s Loosen Needle bar connecting screw A.
lowest position. Note: correct needle position is This will allow you to raise and lower
when you can see a small portion of the eye of needle bar for correct location. Note:
the needle. This picture shows correct location. Check all photos before making any adjustments
Hook Point
Adjusting rotating hook point timing with needle This picture shows needle bar and hook point at the
Turn the hand wheel counter clockwise to locate proper location. After needle bar rise.
needle to its lowest position. At lowest position Note if hook point is not in this location reference
turn hand wheel to raise needle 2.5 mm (1/8
”
) drawing 31 loosen screw D there are three screws.
Hook point should be just above eye of needle. At this point the rotating hook can be moved freely
On its shaft. To locate proper timing.
When adjusting the rotating hook point timing also note that clearance
between notch bottom of needle D and hook point C must be maintained.
Hook can not rub against needle. Also see drawing 31 for better view