Operation Manual

8
Connecting your Mega Quilter 18x8 to your Carriage Assembly (Deck) and
Controls on the Handles
Husqvarna Viking promises the purchaser of this Husqvarna Viking sewing machine to repair
or replace any part, at Husqvarna Viking’s option except exclusions as noted, of this sewing
machine which proves to be defective in workmanship or material under normal personal,
family, or household use, to the extent here stated. Any cables that the Purchaser needs to
connect must be connected with care. Careless connection or disconnection may result in
damage to the cables and/or components that the cables are connected to. Such damage is not
covered under warranty.
Your Carriage Assembly (Deck) comes without the encoders and cables connected. You will have a sheet with
your machine to show how to attach these encoders so that the stitch regulations will work. This cable is routed
to the power box of your machine and plugged into the receptacle on the back of the power box.
This is looking at the back of your machine.
You can see the three connecting receptacles
in the back of the machine. The bottom one is
for your Carriage Assembly (deck). The next
one up is for your controls from the handle
bars. The top one is not used at this time.
Your left and right controls on your handle bar have a cable that runs through the handle bar to connect the two
controllers. You will need to use the supplied Handle Bar cable (9 pin) to connect your left handle controller to
connector on the back of the power box.
The Handle Bar cable (9 pin)
Your Handle Bar cable (9 pin)
connects to the Controller on
the Left handle. Note this
Handle Bar cable (9 pin) only connects to this left controller.