Operators Manual

English-36
MAINTENANCE
Adjusting the Hydrostatic Transmission
Cable
The hydrostatic transmission cable (on the left side) is
adjusted in the following manner:
1. Remove the transmission cover. Loosen both
screws (one on each side) and lift off the
transmission cover.
2. Take apart the ball joint, which is locked with a
locking spring.
3. Ensure that the forward drive pedal is pressed
down completely.
4. Switch the vertical arm to the maximum position
and check that the ball and socket in the ball joint
are aligned.
5. Adjust the socket on the cable if needed.
6. Assemble the ball joint.
7. Put the ball joint’s locking spring in place. Make
sure that the locking spring goes through both
holes on the socket.
6008-603
8009-685