Operators Manual

English-70
LUBRICATION
13. Hydraulic System's Oil Level
1. Remove the transmission cover.
2. Make sure the machine is parked on even ground.
3. Check the oil level, it should be visible in the sight
glass at 20°C.
4. Unscrew the oil container’s cover and fill with SAE
10W/40 engine oil, class SF-CC, until the oil level
reaches the top of the sight glass. Then screw the
oil container’s cap into place and attach the
transmission cover.
The oil and filter should be changed by an authorised
service representative, as described in the Workshop
Manual.
The oil change should be carried out after the first
50 hours and then according to the lubrication
schedule.
The suction filter on the hydraulic tank, see the figure,
should be replaced at the same time as changing the
oil.
Work on the system entails particular demands on
cleanliness and the system must be vented before the
machine is used.
8009-702
8009-703