Operators Manual

4
EN - SAFETY INSTRUCTIONS
and persons with reduced physi-
cal, sensory or mental capabilities
or lack of experience, if they are
supervised or instructed how to
use the appliance in a safe way,
and if they understand the hazards
involved.
Children shall be supervised to
make sure that they do not play
with the appliance.
Cleaning and user maintenance
shall not be made by children with-
out supervision.
Outside CENELEC countries
• Appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capa-
bilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning
use of the appliance by a person responsible for their
safety.
• Children should be supervised to ensure that they do not
play with the appliance.
Part 2:3
Part 2:3 provides a general overview of the machine and
operation elements along with illustrated sections on
preparation, operation, water connection, storage, and user
maintenance.
A Unpacking and preparing for use
Follow illustrations in A.
B Connection to potable water mains
High pressure washers are not suitable for connection
to the potable water mains. Always check national regula-
tions before connecting the machine to potable water mains
and use a back-ow preventer if required.
Use ½" garden hose, 10-25 m.
Follow illustrations in B.
C Connection to other water sources
You can connect the machine to e.g. rain water vessels,
rivers, lakes and cisterns etc. and operate it in suction mode.
Follow illustrations in C.
D Pairing of spray handle and machine
R-models only. After battery insert, D1, you have 2 min. to
pair spray handle and machine. The light will ash orange
when searching for the machine. When paired, the light will
turn off. Follow illustrations D2. If pairing aborts, do pairing
according to illustrations D3. Power regulation is indicated by
green light, see illustration D5.
E Leaving the machine unattended > 5 min.
See listed warnings.
Follow the illustrations
in E.
F After use and storage
After use always:
• Turn off the machine.
• Empty machine and accessories of water to avoid frost
damage.
• Remove the plug from socket.
• Disconnect water inlet hose.
• Wind up electrical cable and high pressure hose to avoid
damage of cable, high pressure hose and ttings.
Storage of machine shall be frost free.
Follow illustrations in F.
G Maintenance, inspection and repair
Maintenance of the machine should always be done when
starting up after long time of storage.
Before use, always in-
spect the machine and
equipment for damages.
In case of damages, act
according to listed
warnings.
Do not attempt any maintenance not described in the instruc-
tions. If the machine refuses to start, stops, pulsates, pres-
sure uctuates, motor buzzes, fuse blows or no water comes
out, check the trouble shooting diagram at our website
www.husqvarna.com.
Any repair should always be made in Husqvarna authorized
workshop with original Husqvarna spare parts.
User maintenance according to illustrations in G.
OM 1-3 Safety 20191114.indd 4 2019-11-14 15:23:25