User manual

41
UK
Installation
The microwave can be fitted in position A or B:
INSTALLING THE APPLIANCE
1. Remove all packaging and check carefully for any
signs of damage.
2. If fitting the microwave oven above a conventional
oven (position A) then use the mylar sheet provided.
a. Cut the Mylar sheet to fit the internal width of
the unit.
b. Peel back the protective cover on the tape and fix
to the rear of the shelf
so that it covers
the service
gap. (See
diagram).
3. Fit the appliance into the kitchen cupboard slowly,
and without force, until the front frame of the oven
seals against the front opening of the cupboard.
4. Ensure the appliance is
stable and not leaning.
Ensure that a 5mm gap is
kept between the cupboard
door above and the top of
the frame (see diagram).
5. Fix the oven in position with the
screws provided.
The fixing points are located on
the top and bottom corners of
the oven (see diagram, item 9,
on page 4).
6. It is important to ensure that
the installation of this product conforms to the
instructions in this operation manual and the
conventional oven manufacturer’s installation
instructions.
CAUTION: When securing this product to any kitchen
furniture, care must be taken not to
overtighten the screws when inserting
through the frame into it’s housing. Prior to
inserting the screws, a pilot hole should be
drilled in the kitchen cabinet. This will allow
easy insertion of the screw. The screws should
only be tightened sufficiently to bottom out in
the frame. Tightening the screws further could
distort the frame itself or damage the kitchen
furniture.
Mylar sheet
Conventional
oven
Internal width
Service gap
POSITION NICHE SIZE CHIMNEY Gap Between
W D H (min) Cupboard & Ceiling
A 560 x 550 x 450 50 50
B 560 x 500 x 450 40 50
Measurements in (mm)
Conventional
oven
Chimney Chimney
5 mm
1. HQ-32D-EU English 26/08/2005 14:23 Page 41