QRT4671W QRT4671X USER MANUAL EN User Manual Fridge Freezer
www.husqvarna-electrolux.se CONTENTS 1. SAFETY INFORMATION................................................................................................... 3 2. SAFETY INSTRUCTIONS...................................................................................................4 3. OPERATION.......................................................................................................................6 4. DAILY USE................................................................................
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. 1.
www.husqvarna-electrolux.se • • • • Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
ENGLISH • Do not change the specification of this appliance. • Do not put electrical appliances (e.g. ice cream makers) in the appliance unless they are stated applicable by the manufacturer. • Be careful not to cause damage to the refrigerant circuit. It contains isobutane (R600a), a natural gas with a high level of environmental compatibility. This gas is flammable. • If damage occurs to the refrigerant circuit, make sure that there are no flames and sources of ignition in the room. Ventilate the room.
www.husqvarna-electrolux.se 3. OPERATION 3.1 Control panel 1 2 9 3 4 5 8 1. Compartment select key and ON/OFF key 2. Display 3. Temperature warmer key 4. FROSTMATIC indicator 5. ExtraHumidity indicator 6. DYNAMICAIR indicator 7. COOLMATIC indicator 8. ExtraHumidity key 9. DYNAMICAIR key 10. Mode key 11. Temperature colder key 6 7 It is possible to change predefined sound of buttons by pressing together temperature warmer key and temperature colder key for 3 seconds. Change is reversible.
ENGLISH Once the maximum or minimum temperature is set, pressing the key again will not change temperature setting. The audible sound is heard. 3.4 Active mode Active mode allows to change any setting in the appliance. To switch on active mode, open the door or hold any button for 1 second until the audible signal is heard. The icons illuminate. The active mode switches off automatically after 30 seconds. 3.
www.husqvarna-electrolux.se 3.9 DEMO mode • acoustic buzzer. DEMO mode allows to operate the panel without activating the appliance. To reset the alarm press any key. The buzzer switches off. The alarm indicators continue to flash until the normal conditions are restored. • To activate the mode, press mode key 9 times, until dE appears on the display. • To deactivate the mode, press mode key for approximately 10 seconds. The appliance returns to regular mode. 3.
ENGLISH In this condition, the refrigerator compartment temperature might drop below 0°C. If this occurs reset the temperature regulator to a warmer setting. 9 The FreshBox module is equipped with runners. At the time of its removal from the fridge compartment pull the module towards yourself and remove the basket by tilting its front downwards. 4.4 Storing food in a fridge compartment Cover or wrap the food, particularly if it has a strong flavour.
www.husqvarna-electrolux.se 5.2 Periodic cleaning To make sure fully functionality of the LongFresh 0° compartment the lowest shelf and cover plates must be put back in their original position after cleaning. CAUTION! Do not pull, move or damage any pipes and/or cables inside the cabinet. CAUTION! Take care of not to damage the cooling system. CAUTION! When moving the cabinet, lift it by the front edge to avoid scratching the floor. The equipment has to be cleaned regularly: 1.
ENGLISH 11 Problem Possible cause Solution Audible or visual alarm is on. The cabinet has been recently switched on or the temperature is still too high. Refer to "Door Open Alarm"or "High Temperature Alarm". The temperature in the appliance is too high. Refer to "Door Open Alarm"or "High Temperature Alarm". The lamp does not work. The lamp is in stand-by mode. Close and open the door. The lamp does not work. The lamp is defective. Contact the nearest Authorised Service Centre.
www.husqvarna-electrolux.se Problem Possible cause Solution Water flows on the floor. The melting water outlet is Attach the melting water outnot connected to the evap- let to the evaporative tray. orative tray above the compressor. Temperature cannot be set. The FROSTMATIC or COOLMATIC function is switched on. Switch off FROSTMATIC or COOLMATIC manually, or wait until the function resets automatically to set the temperature. Refer to "FROSTMATIC or COOLMATIC function".
ENGLISH 13 Problem Possible cause Solution Door does not open easily. You attempted to re-open the door immediately after closing. Wait a few seconds between closing and re-opening of the door. If the advice does not lead to the desired result, contact the nearest Authorised Service Centre. Only service is allowed to replace the lighting device. Contact your Authorised Service Centre. 6.2 Replacing the lamp The appliance is equipped with a longlife LED interior light. 7.
www.husqvarna-electrolux.se 8. TECHNICAL DATA Height 2000 mm Voltage 230 - 240 V Width 595 mm Frequency 50 Hz Depth 647 mm Rising time 17 h The technical information is situated in the rating plate, on the external or internal side of the appliance and in the energy label. 9. ENVIRONMENTAL CONCERNS Recycle materials with the symbol . Put the packaging in relevant containers to recycle it.
ENGLISH 15
280156996-A-201017 www.husqvarna-electrolux.
