Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- Operation
- Maintenance
- Introduction
- Maintenance schedule
- Maintenance and checks of the safety devices on the product
- To do a check of the brake band
- To do a check of the front hand guard
- To do a check of the chain brake
- To do a check of the throttle trigger and the throttle trigger lockout
- To do a check of the chain catcher
- To do a check of the vibration damping system
- To do a check of the start/stop switch
- To do a check of the muffler
- AutoTuneā¢
- To replace a broken or worn starter rope
- To tighten the recoil spring
- To assemble the starter housing on the product
- To clean the air filter
- To do a check of the spark plug
- To sharpen the saw chain
- To adjust the tension of the saw chain
- To do a check of the saw chain lubrication
- To do a check of the spur sprocket
- To lubricate the needle bearing
- To examine the cutting equipment
- To do a check of the guide bar
- To do maintenance on the fuel tank and the chain oil tank
- To adjust the chain oil flow
- To clean the cooling system
- Troubleshooting
- Transportation and storage
- Technical data
- Accessories
- EC Declaration of Conformity
1. Move the front hand guard forward to engage the
chain brake.
2. Push the air purge bulb about 6 times or until fuel
starts to fill the bulb. It is not necessary to fill the air
purge bulb completely.
3. Move the choke to the choke position and then
directly to work position.
4. Continue to
To start the product on page 13
for
more instructions.
To start the product
WARNING: You must keep your feet in a
stable position when you start the product.
WARNING: If the saw chain rotates at idle
speed, speak to your servicing dealer and
do not use the product.
1. Put the product on the ground.
2. Put your left hand on the front handle.
3. Put your knee on the rear part of the top handle.
4. Pull the starter rope handle slowly with your right
hand until you feel resistance.
WARNING: Do not twist the starter cord
around your hand.
CAUTION: Do not pull the starter rope to
full extension and do not let go of the
starter rope handle.
a) If you start your product with a cold engine, pull
the starter rope handle until the engine fires.
Note: You can identify when the engine fires
through a "puff" sound.
b) Put the choke control in choke position.
5. Pull the starter rope handle until the engine starts.
6. Quickly disengage the throttle trigger lockout to set
the product to idle speed.
7. Move the front hand guard rearward to disengage
the chain brake.
8. Use the product.
524 - 003 - 04.06.2019
13