Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- Operation
- Maintenance
- Introduction
- Maintenance schedule
- Maintenance and checks of the safety devices on the product
- To do a check of the brake band
- To do a check of the front hand guard
- To do a check of the chain brake
- To do a check of the throttle trigger and the throttle trigger lockout
- To do a check of the chain catcher
- To do a check of the vibration damping system
- To do a check of the start/stop switch
- To do a check of the muffler
- AutoTuneā¢
- To replace a broken or worn starter rope
- To tighten the recoil spring
- To assemble the starter housing on the product
- To clean the air filter
- To do a check of the spark plug
- To sharpen the saw chain
- To adjust the tension of the saw chain
- To do a check of the saw chain lubrication
- To do a check of the spur sprocket
- To lubricate the needle bearing
- To examine the cutting equipment
- To do a check of the guide bar
- To do maintenance on the fuel tank and the chain oil tank
- To adjust the chain oil flow
- To clean the cooling system
- Troubleshooting
- Transportation and storage
- Technical data
- Accessories
- EC Declaration of Conformity
Contents
Introduction..................................................................... 2
Safety..............................................................................4
Assembly........................................................................ 9
Operation........................................................................ 9
Maintenance................................................................. 17
Troubleshooting............................................................ 27
Transportation and storage...........................................28
Technical data.............................................................. 28
Accessories.................................................................. 29
EC Declaration of Conformity....................................... 31
Introduction
Intended use
This product is for professional tree maintenance such
as pruning and to disassemble tree crowns.
Note: National regulations can set limit to the operation
of the product.
Product description
The Husqvarna T540XP II is a chainsaw model with a
combustion engine.
Work is constantly in progress to increase your safety
and efficiency during operation. Speak to your servicing
dealer for more information.
Product overview
1
31
27
29
28
18
19
20
21
22
30
23
24
25
15
16
17
4
19
5
11
12
26
13
14
6
7
8
9
10
2
3
32
32
1. Front hand guard
2. Stop switch
3. Information and warning decal
4. Top handle
5. Filter cover
6. Choke control
7. Rope eyelet
8. Air purge bulb
9. Fuel tank
10. Fuel level window
11. Starter rope handle
12. Starter housing
13. Front handle
14. Chain oil tank
2 524 - 003 - 04.06.2019