Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- Operation
- Maintenance
- Introduction
- Maintenance schedule
- Maintenance and checks of the safety devices on the product
- To do a check of the brake band
- To do a check of the front hand guard
- To do a check of the chain brake
- To do a check of the throttle trigger and the throttle trigger lockout
- To do a check of the chain catcher
- To do a check of the vibration damping system
- To do a check of the start/stop switch
- To do a check of the muffler
- AutoTuneâ„¢
- To replace a broken or worn starter rope
- To tighten the recoil spring
- To assemble the starter housing on the product
- To clean the air filter
- To do a check of the spark plug
- To sharpen the saw chain
- To adjust the tension of the saw chain
- To do a check of the saw chain lubrication
- To do a check of the spur sprocket
- To lubricate the needle bearing
- To examine the cutting equipment
- To do a check of the guide bar
- To do maintenance on the fuel tank and the chain oil tank
- To adjust the chain oil flow
- To clean the cooling system
- Troubleshooting
- Transportation and storage
- Technical data
- Accessories
- EC Declaration of Conformity
Husqvarna T540XP II
Sound power level, guaranteed L
WA
dB(A) 116
Sound levels
3
Equivalent sound pressure level at the operator’s ear,
dB(A)
104
Equivalent vibration levels, a
hveq
4
Front handle, m/s
2
3.5
Rear handle, m/s
2
4.2
Saw chain/guide bar
Type of drive sprocket/number of teeth Spur 6
Saw chain speed at 133% of maximum engine power
speed, m/s.
25.8
Accessories
Recommended cutting equipment
Chainsaw models Husqvarna T540XP II have been
evaluated for safety according to EN ISO 11681-2:2011
(Machinery for forestry - Portable chainsaws - Safety
requirements and testing. Part 2: Chainsaws for tree
service) and fulfill the safety requirements when
equipped with the below listed guide bar and saw chain
combinations.
Low kickback saw chain
A saw chain that is designated as Low kickback saw
chain, meets the low kickback requirement specified in
ANSI B175.1-2012.
Kickback and guide bar nose radius
Guide bar Saw chain
Length, in/cm Pitch, in Gauge, in/mm Max. nose ra-
dius
Type Length, drive
links (no.)
Low kickback
12/30 3/8 0.050/1.3 9T Husqvarna
H37
Husqvarna
H36
Husqvarna
S93G
45 Yes
14/36 52
16/41 56
The usable cutting length is usually 1 in less than the
nominal guide bar length.
3
Equivalent sound pressure level, according to ISO 22868, is calculated as the time-weighted energy total for
different sound pressure levels under various working conditions. Typical statistical dispersion for equivalent
sound pressure level is a standard deviation of 1 dB (A).
4
Equivalent vibration level, according to ISO 22867, is calculated as the time-weighted energy total for vibration
levels under various working conditions. Reported data for equivalent vibration level has a typical statistical
dispersion (standard deviation) of 1 m/s
2
.
524 - 003 - 04.06.2019 29