Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- Operation
- Maintenance
- Introduction
- Maintenance schedule
- Maintenance and checks of the safety devices on the product
- To do a check of the brake band
- To do a check of the front hand guard
- To do a check of the chain brake
- To do a check of the throttle trigger and the throttle trigger lockout
- To do a check of the chain catcher
- To do a check of the vibration damping system
- To do a check of the start/stop switch
- To do a check of the muffler
- AutoTune™
- To replace a broken or worn starter rope
- To tighten the recoil spring
- To assemble the starter housing on the product
- To clean the air filter
- To do a check of the spark plug
- To sharpen the saw chain
- To adjust the tension of the saw chain
- To do a check of the saw chain lubrication
- To do a check of the spur sprocket
- To lubricate the needle bearing
- To examine the cutting equipment
- To do a check of the guide bar
- To do maintenance on the fuel tank and the chain oil tank
- To adjust the chain oil flow
- To clean the cooling system
- Troubleshooting
- Transportation and storage
- Technical data
- Accessories
- EC Declaration of Conformity
EC Declaration of Conformity
EC Declaration of conformity
Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel:
+46-36-146500, declares under sole responsibility that
the chainsaw for tree-service Husqvarna T540XP II from
2016’s serial numbers and onwards (the year is clearly
stated in plain text on the type plate with subsequent
serial number), are in conformity with the requirements
of the COUNCIL’S DIRECTIVES:
• of May 17, 2006 ”relating to machinery” 2006/42/EC.
• of February 26, 2014 ”relating to electromagnetic
compatibility” 2014/30/EU.
• of May 8, 2000 ”relating to the noise emissions in the
environment” 2000/14/EC.
• of June 8, 2011 ”on the restriction of the use of
certain hazardous substances in electrical and
electronic equipment” 2011/65/EU.
The following standards have been applied: EN ISO
12100:2010, EN ISO 14982:2009, EN ISO
11681-2:2011, EN 50581:2012.
Notified body: 0404, RISE SMP Svensk Maskinprovning
AB, Box 7035, SE-750 07 Uppsala, Sweden, has carried
out EC type examination in accordance with the
machinery directive’s (2006/42/EC) article 12, point 3b.
The certificates for EC type examination in accordance
with annex IX, has the number: 0404/11/2320 – T540XP
II.
In addition, 0404, RISE SMP Svensk Maskinprovning
AB, Box 7035, SE-750 07 Uppsala, Sweden, has
certified conformity with annex V of the Council’s
Directive of May 8, 2000 ”relating to the noise emissions
in the environment” 2000/14/EC. The certificate has the
number: 01/161/089 - T540XP II.
For information relating to noise emissions, refer to
Technical data on page 28
.
The supplied chainsaw conforms to the example that
underwent EC type examination.
Huskvarna, 2017-12-31
Per Gustafsson, Development manager (authorized
representative for Husqvarna AB and responsible for
technical documentation.)
524 - 003 - 04.06.2019
31