Owner's manual

15 WHEELS, TIRES
164
E01130-11
–
Clean the thread of the wheel spindle and screw
2
.
– Clean and grease the wheel spindle.
Long-life grease ( p. 249)
– Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
2
.
Guideline
Screw, front wheel
spindle
M8 26 Nm (19.2 lbf ft)
–
Position wheel speed sensor
3
in the drill hole.
–
Mount and tighten screw
4
.
Guideline
Screw, wheel speed
sensor
M6 8 Nm (5.9 lbf ft)
–
Position the fender, and mount and tighten screws
5
with
the washers.
Guideline
Screw, fender on
axle clamp
M6 7 Nm (5.2 lbf ft)
– Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.