Owner's manual

16 ELECTRICAL SYSTEM
190
16.6 Changing the turn signal bulb
Note
Damage to reflector Grease on the reflector reduces the brightness.
Grease on the bulb will evaporate due to the heat and be deposited on the reflector.
– Clean and degrease the bulbs before mounting.
– Do not touch the bulbs with your bare hands.
K00017-10
– Remove the screw on the rear of the turn signal housing.
–
Carefully remove diffuser
1
.
–
Push bulb
2
lightly into the socket, turn approx. 30° coun-
terclockwise, and pull it out of the socket.
Info
Do not touch the reflector with your fingers and keep it
free from grease.
– Lightly push the new lamp into the socket and turn all the
way clockwise.
Turn signal (RY10W / socket BAU15s) ( p. 237)
– Check that the turn signal is functioning properly.
– Position the diffuser.