Operators Manual

English-37
MAINTENANCE
Blade replacement:
• Remove blade bolt by turning
counterclockwise.
• Install new or re-sharpened blade with
stamped “GRASS SIDE” facing towards
ground/grass (down) or “THIS SIDE UP”
facing deck and cutter housing.
• Install and tighten blade bolt securely.
Torque blade bolt to 45-55 ft/lbs
(60-75 Nm).
Gear Case
• To keep our drive system working
properly, the gear case and area around
the drive should be kept clean and free of
trash buil-up. Clean under the drive cover
twice a season.
• The gear case is filled with lubricant to
the proper level at the factory. The only
time the lubricant needs attention is if the
service has been performed on the gear
case..
WARNING!
The blade is sharp. Protect
your hands with gloves and /or
wrap the blade with a heavy
cloth when handling.
IMPORTANT INFORMATION
To ensure proper assembly, center hole in
blade must align with star on cutter
housing.
1
2
3
4
5
6
1. Blade
2. Blade Adapter
3. Key
4. Lockwasher
5. Blade Bolt
6. Hardened Washer
IMPORTANT INFORMATION
Special blade bolt is heat treated.
Replace with Husqvarna bolt if required.
Do not use lower grade hardware than
specified.
8019-036
Blade assembly