Operators Manual

- 10 -
ASSEMBLY
1. After removing the unit from shipping
container, adjust tire pressure to 10 to 14
psi (70 to 95 kPa).
2. Check the adjustments outlined in
Maintenance.
3. Check engine oil level. See the engine
manual.
4. Add clean fuel to the fuel tank. See engine
manual for type and grade.
5. Check for loose hardware.
6. Make sure that safety interlock system
operates correctly. See Safety Interlock
System.
7. Make sure that unit tracks straight. The
unit must not pull sharply to the left or right
when the steering levers are released.
See Tracking Adjustment.
CAUTION! Avoid injury! Explosive
separation of tire and rim parts is possible
when they are serviced incorrectly.
• Do not attempt to mount a tire without
the proper equipment and experience
to perform the job.
• Do not inflate the tires above the
recommended pressure.
• Do not weld or heat a wheel and tire
assembly. Heat can cause an increase
in air pressure resulting in an explosion.
Welding can structurally weaken or
deform the wheel.
• Do not stand in front or over the tire
assembly when inflating. Use a clip-on
chuck and extension hose long enough
to allow you to stand to one side.