Operators Manual

- 25 -
Replacing Caster Pivot Bearing
Bushings
1. Turn the engine off. Remove the ignition
key. Remove the ignition wire from the
spark plugs.
2. Raise and securely support the front of the
mower deck.
3. Remove lynch pin, spacer bushings,
washer and caster yoke and wheel
assembly.
4. Remove and discard upper and lower
bushings.
5. Install new bushings.
6. Install caster yoke and wheel assembly,
washer, spacer bushings and lynch pin.
7. Apply grease to grease fitting.
IMPORTANT Avoid damage! When
replacing fuses use only 25-amp fuses to
avoid damage to the circuit.
Spacers
Spacer Bushing
Caster Yoke
Lynch Pin
Spacers
Wheel
Spacer
Wheel Assy
Spacer Bushing
Electrical Service
Replacing Fuse
The machine is equipped with one 25-amp
fuse to protect the charging circuit. This fuse is
located on the main harness, near the engine
ground. Replace with an automotive type 25-
amp fuse.
1. Remove defective fuse from socket.
2. Check metal clip in fuse window and
discard fuse if clip is broken.
3. Install new fuse into socket.
IMPORTANT Do not allow washer to sit
on caster yoke. It must be on top of the
height-of-cut spacer bushings
Washer
Grease Fitting