Operators Manual

- 27 -
TROUBLESHOOTING
Problem Probable Cause Correction
Engine will not start Safety Interlock System is
preventing start
Make sure the shift lever is
in neutral, the ignition key is
in the ON position, and the
Power Take Off is OFF
Fuel tank empty or fuel is
contaminated
Add fuel or replace with
clean, fresh fuel
Air cleaner is clogged or
damaged.
Clean or replace the filter
element see engine manual
Safety Interlock System out
of adjustment or defective.
See dealer for repairs
Dirty or faulty spark plug See engine manual
Unit will not move or mow
with engine running
Transmission belt or mower
belt is broken, worn, or off the
pulleys.
Check belts for wear, damage
and correct position on
pulleys. Replace belts if worn
or damaged. See Replacing
Transmission Belt
Changes in the sound or
vibrations of the unit
Loose or missing fasteners Check all the fasteners.
Tighten or replace as
necessary.
Mower blade problem Check blades for wear or
damage. See Mower Blades
Worn or damaged clutch See dealer for repairs
Unit does not straighten
immediately when the
steering levers are released
Steering levers out of
adjustment
See Adjusting Steering
Levers
Erratic movement of cylinder Air in hydraulic system Purge air from hydraulic
system
Unit loses power Binding in the steering or
brake linkage
Check linkage for debris or
damage. Repair if necessary.
See Adjusting Brakes or
dealer for repairs
Steering levers out of
adjustment
See Adjusting Steering
Levers
Worn or damaged traction
belts
Check belts for wear
or damage. Replace if
necessary. See Replacing
Traction Belts
Traction belt slipping Move the traction belt idler
spring anchor to the rear
most position. See Replacing
Traction Belts
Transmission shaft pulley
worn
Check pulley for excessive
wear, replace if necessary.
See your Dealer for repairs