User manual

Rev. 0010

6. VERTICAL AND FRONT TO BACK ADJUSTMENT

AND OPENING OVERLAP PROBLEMS

• VERTICAL ADJUSTMENT

1. Remove 2. Lift open 3. Loosen hex screw 4. Add or remove 5. Close glass panel(s)

top glass glass panel(s) (1/4" allen). shims as needed. and check alignment

and panel and relieve Remove chrome (see note on shims Retighten hex screw

enclosing tension on access plate in order below) and reinstall removed

mini-top hinge. to hold nut plate. components.

hardware.

• FRONT– BACK ADJUSTMENT

1. Remove 2. Estimate 3. Lift open 4. Loosen hex screw 5. Slide the mini-top

top glass amount of glass panel(s) (1/4" allen) slightly. forward or backward

and panel adjustment and relieve Remove chrome to the mark in step 2.

enclosing and make tension on access plate in order Check alignment of

mini-top pencil mark hinge. to hold nut plate. glass.

hardware. on the Retighten components.

Back

of Case

Inside

of Case

Chrome cap

for access to

nut plate

nut

plate

CUT VIEW:

Mini Top

Hardware

NOTE: Standard shim thickness is 1/16"