Corp. Network Router User Manual

CONFIG MENU (continued)
3- TEMP #1
3 - T E M P # 1 allows you to establish set point
and alarm levels for the first temperature
i n p u t .
Press 3 on the Keypad to enter the TEMP #1
Submenu.
The
ALM DELAY is a programmable time delay.
This sets the time it will take before the control
log’s the alarm.
The CIRCUIT - X allows you to attach a defrost
circuit to the temperature input (or vice versa).
When the circuit is in defrost, the HI ALARM will be
ignored.
Press CLR. Key in your selection and
press ENT.
Using the key, toggle ENABLED or DISABLED.
Press ENT.
Press ESC to return to S
E N S O R SE T U P ME N U.
4- TEMP #2
Press 4 on the Keypad to enter the TEMP #2
Submenu. Follow instructions above.
5- TEMP #3
Press 5 on the Keypad to enter the
TEMP #3
Submenu.
If split suction is installed, TEMP #3 may be
f a c t o ry set to read head pressure instead of
temperature. This is accomplished by changing
the input mode to Pressure.
If split suction is not installed, TEMP #3 is a
designated temperature input; but if you prefer it
can be factory set as a pressure input.
Using the key, toggle
TEMP or PRESS. Press
ENT.
Press ESC to return to SE N S O R SE T U P ME N U.
3
4
5
Note: When using T3 for a pressure reading,
remember to place the hardware switch on the
main control board in the pressure position.
970307 HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 (Printed in U.S.A.)
P/N 374511B
Page 13
PROTOCOL
™
Hand Held Device
TEMPERATURE # 1
SET PT - XX F
HI ALARM - XX F
LO ALARM - XX F
ALARM - ENABLE
ALM DELAY - 30 MIN
CIRCUIT - X
TEMPERATURE # 2
SET PT - XX F
HI ALARM - XX F
LO ALARM - XX F
ALARM - ENABLE
ALM DELAY - 30 MIN
CIRCUIT - X
TEMPERATURE # 3
INPUT MODE - TEMP
SET PT - XX F
HI ALARM - XX F
LO ALARM - XX F
ALARM - ENABLE
ALM DELAY - 30 MIN
CIRCUIT - X
SENSOR SETUP MENU
1-PRESSURE #1
2-PRESSURE #2
3-TEMP #1
4-TEMP #2
5-TEMP #3