User Guide

IGSV-ASCS-0303

Maintenance (continued)

1. Remove 2. Lift open 3. Loosen hex screw 4. Add or remove 5. Close glass panel(s)

top glass glass panel(s) (1/4" allen). shims as needed. and check alignment

and panel and relieve Remove chrome (see note on shims Retighten hex screw

enclosing tension on access cap in order below) and reinstall removed

mini-top hinge. to hold nut plate. components.

hardware.

1. Remove 2. Lift open 3. Loosen (4mm) 4. Move panel

top glass glass panel(s) screw slightly. as required

enclosing and relieve one at each hinge Retighten components

mini-top tension on

hardware. hinge.

Back

of Case

Inside

of Case

Chrome cap

for access to

nut plate

nut

plate

CUT VIEW:

Mini Top

Hardware

Adjust glass Up and Down

(vertically)

Adjust glass Side to Side

(horizontally)

Adjust glass Front to Back

NOTE: Before making any of the recommended adjustments,

Verify that the case(s) have been leveled properly.

1. Remove 2. Estimate 3. Lift open 4. Loosen hex screw 5. Slide the mini-top

top glass amount of glass panel(s) (1/4" allen) slightly. forward or backward

and panel adjustment and relieve Remove chrome to the mark in step 2.

enclosing and make tension on access plate in order Check alignment of

mini-top pencil mark hinge. to hold nut plate. glass.

hardware. on the mini-cam. Retighten components.

NOTE: Standard shim thickness is 1/16"

RGSDS hardware shown

Tech/glassadj/970602 tn