User Guide

9. Set the amount of threads protruding on the deck lift rod from the lift
block at approximately 1". Fig. 10-36
10. Jam both nuts against the block.
11. Push or pull on the deck lift foot pedal until the chain on the left
front just becomes tight, making sure that the deck stays tight against
the 4" block.
12. While keeping the chain tight, tighten the nuts against the deck lift
block on the height indicator rod. Fig. 10-35
13. Go to the right front of the tractor.
14. Loosen the 5/16" jam nut on the adjuster lift chain (10-34), and back
the adjuster bolt out to allow the adjuster to move up and down
freely.
15. Be sure that adjuster is free to move up and down.
16. Tighten the adjuster bolt until the chain just becomes tight, making
sure that the deck stays tight against the 4" block.
17. Tighten the adjuster bolt jam nut to prevent the adjuster bolt from
moving. Fig. 10-34
18. Tighten the hardware holding the chain and adjuster onto the deck
lift arm.
19. Go to the right rear of the tractor.
20. Make sure that there is still slack in the chain. If not, loosen the two
nuts on the block holding the threaded rod until there is slack in the
deck lift chain. Fig. 10-33
21. Tighten the appropriate nut until the chain just becomes tight,
making sure that the deck stays tight against the 3" block.
22. Tighten the other nut on the opposite side of the block, and jam them
tightly together against the block.
23. Go to the left rear of the tractor.
24. Make sure that there is still slack in the chain. If not, loosen the two
nuts on the block holding the threaded rod until there is slack in the
deck lift chain. Fig. 10-32
25. Tighten the appropriate nut until the chain just becomes tight.
26. Tighten the other nut on the opposite side of the block, and jam them
tightly together against the block.
27. Compress the deck lift assist springs so that there is 1” of space
between the front nut and on the spring and the rear nut on the deck
lift block (Fig. 10-36). Typical both sides.
28. When completed, all chains will be tight, and deck cutting height
will be set to the deck height indicator.
Figure 10-28
Spring
Tension idler
Chain
Anchor
bracket
106567_0706
10-18
Figure 10-29
3.0”
Spring Extension
9.0”
6.0”
Figure 10-27
Spring
Tension
idler
Pump drive
belt
Normal Spring Length
Figure 10-30
Blocks