User Guide

1-2 302612 5/05
Hardware Description Codes & Abbreviations
The following codes are used throughout this parts manual. Refer to this list when ordering parts.
Standard Torques
The following chart lists the standard torque values for the threaded fasteners found in this manual. Torque all cap
screws, nuts and set screws to these values unless a different torque is shown in the Notes section next to the fastener
NOTE:
Loctite 592 to be used on all pipe threads.
Lubricate all grease zerks.
ABBREVIATION DESCRIPTION
CB
Carriage Bolt
CE
Clevis Pin
CP
Cotter Pin
CS
Cap Screw
CW
Cup Washer
FDRW
Fender Washer
FW
Flat Washer
HX
Hex Head
LW
Lock Washer
MB
Machine Bushing
MS
Machine Screw
NT
Nut
SC
Self Tapping Cap Screw
SH
Socket Head
SB
Shoulder Bolt
SS
Set Screw
OD
Outside Diameter
ID
Inside Diameter
SIZE FT-LBS NM SIZE FT-LBS NM
.250 8.2 11.1 M3 1 1.3
.312 17 23 M4 2.2 3
.375 30 40 M5 4.5 6.1
.438 48 65 M6 7.7 10.4
.500 73 99 M8 18.5 25
.562 105 143 M10 37 50
.625 145 200 M12 64 87
.750 260 350 M16 160 215
.875 420 565 M20 320 435
1.00 625 850 M24 555 750