User Guide

2-6 339622 8/06
Deck Subassembly
NOTES:
1. Item 9, pulley, must be in the same horizontal plane as the item 28, drive
pulleys, within ± .03" tolerance.
2. Assemble item 30, spindle housing, so the grease zerk faces the front of
the deck.
3. Torque to 65-75 Ft. Lbs.
4. Item 4, gearbox, to be filled to center of sight gauge upon installation
with Amaco 80W-10 or equivalent gear lube.
5. Tighten item 6, nut, to 20 Ft. Lbs. then loosen 1/4 turn.
6. Apply lubrication to both sides of bearing disc. Use Vasoline or 716555
grease.
7. Shaft & exposed end of bearings must be free of rust & wiped clean.
Then coat entire shaft & exposed end of bearings with antiseize
lubricant 705715.
8. Wipe clean & coat entire surface of shaft with antiseize lubricant
705715.
9. To check proper blade alignment, both ends of center blade must align
with both end of outer blades. When blade tips are closest together they
must be within .20" vertically.
10. See 2-7 for breakdown.
11. Air vent must be free of paint.