User Guide

339622 8/06 3-3
Gauge Arm Assembly - 466888
INDEX
NO.
SERVICE
PART NO.
MFG. PART
NO.
QTY. DESCRIPTION
1 016527 016527 1 CS .50-13 X 1.00 HX G5 ZN
2 017046 017046 1 LW .50 MEDIUM SPRING ZN
3 344267 344267 1 FW .510 X 2.150 X .187 SPL ZN
4 082180 082180 2 MB 1.00 X 1.50 X .049 PN
5 077123 077123 2 BEARING
6 310185 310185 1 SPACER
7 532911 083584 1 GAUGE WHEEL ARM
8 506428 506428 1 GAUGE WHEEL FORK
9 049148 049148 1 OIL SEAL
10 049155 049155 2 BEARING
11 049163 049163 2 BEARING CUP
12 747410 747410 1 GAUGE WHEEL 6 X 3.5
13 019521 019521 1 VALVE STEM
14 747402 747402 1 TIRE 13 X 5 X 6
15 048850 048850 1 MACHINE BUSHING
16 048868 048868 1 NT .75-16 HXSL PN
17 011387 011387 1 CP .125 X 1.250 LG HML ZN
18 049171 049171 1 DUST CUP
19 017350 017350 1 SS .25-20 X .250 SH BO
20 466698 466698 1 GAUGE WHEEL ARM HANDLE
21 315226 315226 1 HANDLE PIN
22 466680 466680 1 LOCK LINKAGE
23 315234 315234 1 LINKAGE PIN
24 017277 017277 1 CP .187 X 1.00 LG HML ZN
25 068759 068759 15 CW .560 X 1.340 X .050 PN
26 466672 466672 1 LOCK PIN
747428 747428 TIRE & WHEEL ASSEMBLY (INCLUDES ITEMS 11-14)
NOTES:
1. Pack wheel bearings thoroughly with grease before installing.
2. Fill wheel hub cavity between bearings approximately 2/3 full with
grease.
3. To adjust wheel bearing, raise wheel off floor, tighten item 16, nut, while
rotating the wheel, until there is a slight bind to be sure all bearing
surfaces are in contact.Then back off nut 1/6-1/4 turn to nearest locking
hole or sufficiently to allow wheel to rotate freely within limits of .001"-
.010" (ref) end play. Lock nut at this position by installing cotter pin.
4. Fill cap 3/4 full with grease then press into wheel hub.
5. Do not fully spread item 24, cotter pin, for quicker adjustment of
washers.
6. Use as spares.