Installation Instructions

4 / 6
Name
Description
Nonfunctional
Turn on
Turn off
Color ring
Static color options, 64 colors in total.
Dynamic modes, 8 modes in total.
White color hot key
6 static colors (cyan, purple, yellow, blue, green, red)
6 static colors ( red, green, blue, yellow, purple, cyan)
Brightness – for static colors by 1024 levels. Long-press can get fast adjusting.
Brightness + for static colors by 1024 levels. Long-press can get fast adjusting.
Speed down for dynamic mode (100 levels). Long-press can get fast adjusting.
Speed up for dynamic mode (100 levels). Long-press can get fast adjusting.
Zone selection, 2 seconds long-press get “all-control”.
8 dynamic modes as below:
No
Patterns
Remarks
No
Patterns
Remarks
1
White breathe
Speed is adjustable,
brightness is
unadjustable
5
7 color fade
Speed is adjustable,
brightness is unadjustable
2
3 color jumpy
6
R/G cross fade
3
7 color jumpy
7
R/B cross fade
4
3 color fade
8
G/B cross fade
About RF code.
The biggest advantage of this system is that it can not only solve the cabling problem in engineering
wirelessly, but also realize a wired-like operation experience. In order to facilitate the early testing and
debugging of the project, the factory status of the receiver is normally unpaired and each remote controller
has a unique code value. The user should perform the matching work of the remote controller and the
receiver during the installation of the project to avoid the mutual influence of the radio frequency remote
control technology during the later use.
Please pay attention to the following 3 points before operation:
1) All equipment in the complete system after installation should have a unified and unique code value,
so as to achieve the security and stability of the system.
2) The receiver can only store one code value and cannot be overwritten. Before learning the new code
value, it is necessary to clear the original code of the receiver; the remote controller can only save one
code value but can be overwritten and can also restore the factory settings. In order to facilitate the later
maintenance, the three components that may be involved in the system (including receivers, handheld
remote controllers, and panel remote controllers) can realize mutual learning of code values.
3) Since the receiver performs code value learning in the power-on state, batch-operation is available
(power-one the all receivers which will be in same zone, and operate the matching/clearing the RF
code all of them at the same time). And in order to avoid confusion in the area, it is recommended that
each area has an independent power switch so that the power of other areas can be easily cut off when the
code is being operated.