Installation Instructions

5 / 6
（1）Code pairing operation: means that the receiver will only be controlled by the value code
remote controller.
Step
Operation
Instructions
1
Connecting the load to the receiver and power on it.
1.It is necessary to clear the code first, if the receiver
was coded before.
2.Batch operation can be performed within the
remote control range.
2
Select area
Select the area with the "Zone" key and the
corresponding indicator lights up
3
Press and hold “ON” on the remote control for 5
seconds, the indicator of the remote control will flash
quickly, means it enters the pairing code transmission
status.
Will automatically exit code transmission status after
60 seconds, or pressing any key to exit.
4
See the load light flashes 3 times and return to the initial
state
Pairing coding is finished successfully
（2）Code clearing operation: means that the original code value of the receiver will be cleared
and returned to the factory state. Then it can be controlled by any compatible remote controller,
and can learn to a new code.
Step
Operation
Instructions
1
Connecting the load to the receiver and power on it.
1. The clearing operation should be finished within 1
minute after the receiver is powered on. If exceeds
the time, can be powered on again.
2. Batch operation can be performed within the remote
control range.
2
Press and hold the remote control “Off” for 5 seconds.
The indicator of the remote control flashes quickly,
means it enters the clearing code transmission status.
There is no need to select the corresponding area
when clearing code.
1. Will automatically exit code transmission status after
60 seconds, or pressing any key to exit.
2. If the original remote controller is lost, the new remote
controller can be used for clearing operations.
3
See the load light flashes 3 times and return to the
initial state
Clearing coding is finished successfully
（3）Code learning operation between remote controls: Used to unify system code values or copy
a new remote controls.
Since each remote controller has its own unique code at the time of delivery, when there are multiple
remote controllers in one system, one of them (for example, remote controller A) must be selected as the
system code value, and the code value of the rest remote controllers (for example, remote controller B)
should be copied to the same one.
Step
Operation
Instructions
1
A remote control：Press and hold “ON” on the remote
control for 5 seconds, the indicator of the remote control will
flash quickly, means it enters the pairing code transmission
status.
Will automatically exit code transmission status
after 60 seconds, or pressing any key to exit.
2
B remote control: long press "mode key" for 5 seconds, the
remote indicator light changes from 100% light to off then
flash, means entering the code value receiving state
Will automatically exit the code value receiving
state after 30 seconds, or exit after learning the
code value successfully.
3
see the B remote control indicator light flash 3 times
Code copying is finished and exit code value
receiving status.