Operation Manual

5
WIJZI G I N GEN E N T YPE F O U TEN VOORB E H O UDEN
WIJZI G I N GEN E N T YPE F O U TEN VOORB E H O UDEN
WIJZI G I N GEN E N T YPE F O U TEN VOORB E H O UDEN
3.2 machinedelen
4. machine VeranKeren
Kop
Hendel
v-snaarspanning
Hoogteverstelling
tafel
Noodknop
Motor
Boorkop
Voet
Tafel
Beschermkap
Voedingshendel
Poeliebeschermkap
Tandheugel
Kolom
Afbeelding 2
4.Slide the arbor into the spindle socket whileslowly rotating the drill chuck. The socket hasa
rectangular pocket where the tang (or flatportion of the arbor shown in Figure 21) fitsinto.
5.Seat the chuck with a rubber mallet, as shownin Figure 22.
1-8.Setting the machine instruction:
1.The machine base with setting hole will be set on concrete floor.
The outlined procedures of setting the machine
MODEL
AREA
SETTED SCREW
JTD-16 series X=800×600 M10
2
.The dimension of setting hole:
JTD-16series
10
Figure 21
Figure 22
Wood
Tang-SideUp
X = 770x580 mm
Gebruik stelschroeven M10
Afbeelding 3