Operation Manual
13
CHANGES AND TYPING ERRORS RESERVED CHANGES AND TYPING ERRORS RESERVED
4. Technical specificaTions
No. Description Measure Unit
1. Maximal drilling diameter 30 mm
2. Distance between axis of spindle – column surface 320 mm
3. Max. distance between spindle nose and work table surface 620 mm
4. Max. distance between spindle nose and base surface 1180 mm
5. Max. spindle travel 135 mm
6. Max. travel of work table and bracket 550 mm
7. Horizontal swing of table on bracket ± 45 degree
8. Taper of spindle bore 3 Morse
9. Number of spindle speeds 12 steps
10. Range of spindle speeds 72-2600 rpm
11. Number of spindle feeds 3 steps
12. Spindle feed range 0.1, 0.2, 0.3 mm/rev.
13. Column diameter 120 mm
14. Table working area 500 x 450 mm
15. Base working area 370 x 360 mm
16. Work table and base T-slots 2 x14 mm
17. 3-phase, 2-speed AC motor
Power 1 / 1.5 kW
Voltage 380 (220, 400, 420) V
Speed 960 / 1450 rpm
18. 3-phase electrical pump
Power 0.085 kW
Voltage 380 (220, 400, 420) V
Capacity 6 l/min
19. Electromagnetic clutch
Power 0.024 kW
Voltage 24 V
20. Machine dimensions (LxWxH) 870 x 510 x 2120 mm
21. Machine weight nett 440 kg
22. Noise level information 74/76 dB(A)
Subject to change.
5. TransporTaTion and insTallaTion
5.1. TransporT of The machine
• Handle with care when transporting the machine, Pay close attention to the shipping marks. Don’t lay down
the machine on the wrong side. Avoid impact.
• The machine is fully assembled and packed before shipping to the customer. Please check carefully when
opening the package and make sure no parts are missing.
• When lifting the machine by crane, the center of gravity should be closely watched. For the correct method,
seef figure C. To avoid damaging the machine surface, preferably put soft materials between the rope and
the machine surface.
5.2. foundaTion and insTallaTion
• Take the work table as radius, go 360° around the column to determine the max. area of the foundation. The
diameter of the foundation is 1430 mm (see figure B). Customers can decide the foundation area according
to their own needs.
• The depth of the foundation is chosen so that it rests on a dense soil. The depth shown in figure D is just for
reference.
• Pour concrete around the foundation bolts after setting these in the accurate positions. After solidification of
the concrete, place the machine on the foundation and tighten the foundation bolts. Check adjustment with
a spirit level in longitudinal and transversal direction.
Figure C – Machine transportation
Figure D – Foundation and installation