Mounting the stove on a wall

MOunting the stOve On a wall
1.
Place the wall bracket on the wall at the desired height. Mark the 8 holes in the wall bracket on the wall
and drill the holes. It is recommended to use raw plugs of steel. If the flue duct is connected to a rear
smoke outlet, mark the large hole in the wall bracket, and drill the hole.
Secure the wall bracket to the wall with screws. It is very important to ensure that the bracket is com-
pletely level.
2.
Lift the stove up onto the two hooks on the wall fitting. For proper fitting, make sure that the stove
rests securely in the hooks.
3.
Then attach the two accompanying 6 mm bolts, one at each side of the stove bottom plate. This locks
the stove into the wall fitting. Do not overtighten the bolts, as the metal should be able to expand with
the heat generated by normal use of the stove.
Building material Producer Type and designation
Concrete,
solid brick or
hollow brick
Hilti HUS-H 10,5 x 55
Expandet MMS-S 7,5 x 50
Fischer FBS 8/5 US
Air-entrained
concrete
Expandet LB metal M10 air-entrained concrete anchor
Fischer FTP M 10 + set screw M10 x 25 mm steel
The wall’s plaster work is not accounted for in the sizes listed above. The anchor’s effective length must
therefore be increased by at least the minimum thickness of the plaster work.
Important! The wall fitting may not be screwed into brick joints.
english