User's Manual 4620 4640 4660 EN 4680 22.05.2017 / 97-9685 www.hwam.
Table of contents, English Drawings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-8 HWAM Autopilot IHSTM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 For UK - The Clean Air Act 1993 and Smoke Control Areas. . . . . . . . . . . . . . 10 Installation. . . . . . . . . . . . . . . . . .
A. B.
C.
E.
F.
G.
HWAM Autopilot IHS™ English Congratulations on your new wood-burning stove complete with a HWAM Autopilot IHSTM IHS is short for “Intelligent Heat System”, which is a digital control of the combustion in your new wood-burning stove. The purpose of the HWAM Autopilot IHSTM is to control the combustion in an environmentally optimal and economically efficient way, with a view to generating greater user comfort.
For UK - The Clean Air Act 1993 and Smoke Control Areas Under the Clean Air Act local authorities may declare the whole or part of the district of the authority to be a smoke control area. It is an offence to emit smoke from a chimney of a building, from a furnace or from any fixed boiler if located in a designated smoke control area.
Installation General information Installation of your HWAM woodburning stove must always comply with local building regulations. It is a good idea to consult your local chimney sweep before installing. Always follow the instructions of the manual carefully and make sure that the installation is carried out by a qualified professional. HWAM packaging material should always be handled in accordance with the local rules for waste handling.
Distance to inflammable materials Your HWAM woodburning stove should always be installed on a non-combustible hearth. If it is installed on a wooden floor or similar, the floor must be covered with a non-combustible material. Min. distances - uninsulated flue gas pipe: (drawing A) 1. Recommended for brick wall, back, cm 2. Recommended for brick wall, side, cm 1. For inflammable wall, back, cm 2. For inflammable wall, side, cm 1.To inflammable wall, corner installation, cm 3.
Changing the smoke outlet from top outlet to rear outlet (HWAM 4660/4680 IHS) (Drawing F) 1. Remove the heat storage compartment front (1) by lifting the front and pulling away from the stove. 2. Lift the top plate (2) off the stove. 3. Remove the rear plate (3) by loosening the two screws (4). The rear plate has a cut-out for the flue pipe. Cut out the plate (5) within this cut-out. 4. The heat shield has a cut-out for the flue pipe. Cut out the plate (6) within this cut-out. 5.
Air box withour power supply. Air box with power supply. Follow the instructions in the separate manual for linking stove, room temperature sensor and app. If you do not wish to use an app to control the stove, a remote control can be purchased. In this case, follow the instructions in the manual supplied with the remote control. The remote control replaces the use of room temperature sensor and app.
If the stove has not been used for a longer period, it is important to check that the chimney pipe is not blocked. It is possible to connect several devices to the same chimney. However, it is important to first check the applicable rules. Even a good chimney can function badly if it is not used correctly. Similarly, a bad chimney may function well if used correctly. Chimney sweeping To prevent the risk of chimney fires, the chimney must be cleaned every year.
Recommended dimensions The dimensions of the fuel are important to good combustion. The dimensions should be as follows: Fuel type Length in cm Diameter in cm Wood for kindling a fire (finely chopped) 30-45 2-5 Chopped wood 30-45 7-9 Special fire lighting guide for stoves with soapstone or sandstone cladding Soapstone and sandstone are natural products which need to adjust to temperature changes. We recommend following the procedure below: 1.The first stoking Open the door.
Important! The door must not be opened when lighting up. It must always be closed when the stove is in use. Otherwise the stove’s intelligent control system does not function. The door should only be opened when lighting up, when restoking, and when cleaning the stove. Never leave a stove before there are lasting flames in the wood after firing! The Thermostat Function The HWAM Autopilot IHSTM will in general have an environmentally friendly combustion and adapt to the desired room temperature.
Operating the heat compartment damper There is a damper at the back of the stove between the top plate and the heat compartment that opens and closes the flow of convection air in the heat compartment.The supply of convection air can be opened by moving the damper to the left and closed by moving the damper to the right. To store heat in the heat storage stones in the heat storage compartment as quickly as possible, it is recommended that the convection vent be kept closed while the fire is lit.
before it is stored indoors. It is recommended that kindling wood is stored indoors for a couple of days prior to use. The stove is EN 13240 approved for firing wood only. No particle board, lacquered, painted or treated wood, plastics, or rubber may be burned. Maintenance Cleaning Any maintenance of the stove should only be carried out when it is cold. Daily maintenance is limited to vacuum cleaning the stove externally, using the soft brush attachment.
Maintenance Alarms If a maintenance alarm goes off, you can continue using the wood-burning stove, but contact your dealer as soon as possible.Your stove could be affected by impure combustion. Operational problems Blackened glass • The wood is too damp. Only use wood stored for at least 12 months under cover and with a moisture level not exceeding 18% RH. • The door gasket may be leaking. Smoke in the room when opening door • The grate in the chimney may be closed. Open the grate.
