User's manual

13
Changing the smoke outlet from top outlet to rear outlet (HWAM 4660/4680 IHS)(Drawing F)
1. Remove the heat storage compartment front (1) by lifting the front and pulling away from the stove.
2. Lift the top plate (2) off the stove.
3. Remove the rear plate (3) by loosening the two screws (4). The rear plate has a cut-out for the ue
pipe. Cut out the plate (5) within this cut-out.
4. The heat shield has a cut-out for the ue pipe. Cut out the plate (6) within this cut-out.
5. Remove the cover plate (7) on the rear of the stove (behind the cut-out plate in the heat shield) by
removing the three screws (8).
6. Open the metallic tabs (13) and take the wires out.
7. Pull the lambda sensor coupling (14) free of the wire fastener (15).
8. Remove the temperature monitor (16) from the smoke ring (9).
9. Remove the smoke ring (9) above the combustion chamber by removing the three screws (10).
10. Place the smoke ring (9) in front of the ue outlet hole on the rear of the stove and afx using the
three screws (10).
11. Reattach the temperature monitor (16) in the smoke ring, leading the sensor about 3 cm into the
smoke ring.
12. Reposition the lambda sensor coupling (14) in the wire fastener (15).
13. Fix the two wires by closing the metallic tabs (13) again.
14. Place the cover plate (7) so that it closes the ue outlet on top of the combustion chamber (where
the smoke ring was just removed) and afx using the three screws (8).
15. Place the rear plate (3) on the guide taps (11) on the rear side of the stove's base plate and afx the
rear plate using the two top screws (4).
16. Lie the top plate (2) on the stove.
17. Place the cast-iron or stone top cover (12) in the hole in the top plate.
18. Re-attach the front (1) to the heat storage compartment.
Fitting the loose parts
Before the stove is installed, you must ensure that all loose parts are tted correctly. Make sure that
the chimney is tight and that no false draft is caused around neither the cover plate, in connection
with a covered smoke outlet, nor the cleanout door and pipe connections. Please note that bent and/
or horizontal smoke pipes will reduce the effect of the chimney draft.
Vertical cross-section of the stoves (Drawing B)
1. Bottom smoke shelf. Must rest on the steel rail at the back of the combustion chamber.
2. Top smoke shelf. Must rest on the bottom smoke shelf.
3. The steel smoke guide plate is in two parts. Each half hangs on a hook under the top plate and is
equipped with two pins (7) that serve as protection during transportation. Remember to remove
the two pins before you start using the stove.
4. Rear ue outlet. Closed at the factory using a plate afxed with screws. The ue outlet is thus concealed
behind the rear plate.
5. Removable rear plate. Must always be installed if the stove is next to a ammable wall.
6. Loose heat shield under the ash pan.
Adjustment feet
The stove comes with four adjustment feet. Mount and adjust the adjustable feet screws in accordance
with the separate instructions, 2 in each side, to the desired height.
Connecting and preparing the HWAM Autopilot IHS
TM
Before the stove can be used it must be connected and prepared. Start by connecting the power adapter
to the Airbox that sits in the space under the combustion chamber.