User's Manual

Clicking the button will configure the Patroller unit to toggle an alarm

when there is a leak and/or when there is not. This is not compulsory, and can be

left blank.

Clicking the button will give details of the Patroller unit’s battery.

Clicking the button will give the current version of the Patroller unit’s

firmware.

Note: the Patroller Setup is only available with a mobile Patroller unit, and not the

USB wireless module.

Connections

The Connections function sets up the connection between loggers and the

software. The logger data my come from the logger, the DataGate, or from a file

stored on the computer’s hard drive. The Connections window allows connections

to be tested to make sure data would be transmitted to the software, depending on

the interface.

Patroller/USB Wireless

The Patroller/USB Wireless interface uses either the Patroller unit or the USB

Wireless module.

Note: to connect to the Patroller unit, a Bluetooth connection must be made, and

may take several attempts at pairing before a successful connection is made.

To confirm there is a successful connection, select the port number of the

communications interface, GPS module (if used), and GSM modem (if used), and

click either the button (if using the USB Wireless

module), or the button (if using the Patroller unit).

Upon successfully connecting, a message should appear in the bottom left of the

window saying, “Connected to XX”, where XX is either the Patroller unit or the USB

Wireless module.