User's Guide

485-022-V2
485-024-V2
FCC ID: RUZ-485
Temperature
Part number : MAN -485-0030 -B
If further support or assistance is required, please contact FCS
Technical Support on 1 -800 -531 -5465
or e -mail sales@uidconservaon.com
WARNING: - LITHIUM BATTERIES
If baeries are exposed - do not short circuit, re -charge, puncture, incinerate, crush, immerse, force
discharge or expose to temperatures above the declared operang temperature range of the product.
Risk of re or explosion . These baeries are sealed units which are not hazardous when used according
to the recommendaons of the manufacturer.
2. OPERATION
The reed switch is located on the front right of the unit. The unit will normally be
transming out of the box. If a restart is required or the unit doesn’t appear to transmit,
use the reed switch to iniate transmission. Hold a magnet to close the reed switch and
cause the rmware reset. A click from the reed switch may be heard followed by a
transmission burst.
Reed switch operaon can be veried using an RF scanner tuned to the transmission
frequency, when transming a burst or blip can be heard.
1. INSTALLATION
Opmum operang temperature should be below +50°C. We cannot guarantee the maxi-
mum life; therefore it is recommended to keep within the opmum operaon tempera-
ture range for maximum baery performance.
If monitoring hot water systems it is not advisable to mount the transmier directly on the
pipe without intervening insulaon.
For maximum transmission range the antenna of the transmier should point upward
(vercal polarizaon) and should be kept clear of obstrucons, parcularly metallic
surfaces. Mounng brackets are available, to t the cavity at the rear of the transmier.
Operang in extreme environmental condions will degrade the life -me of the baery.