Manual

MODEL S1.5A
1 1/2” (38 mm) Discharge
1 1/2” HYDRAULIC SUBMERSIBLE
SLIM-LINE PUMP
The S1.5A is designed to be used as a
dewatering pump in areas where space
is limited . Typical uses for this pump
include manhole, vault, blasthole, mine
and construction jobsite dewatering.
FEATURES
•
Small Overall Size Allows Pump To Fit
Through 6" Diameter Opening
•
Oil Lubricated Seals (can run dry)
•
Variable Speed hydraulic drive
•
Stainless Steel Impeller resists wear
•
Rubber Coated Suction Case resists
abrasion
•
Safe Hydraulic Drive can be used where
electric power is hazardous or impractical
•
Dependable gear type hydraulic motor
•
Operates with our HT6 to HT13 power units
or other hydraulic power sources capable of
flows of 3-7 GPM
B0109
167 Stock Street, Nesquehoning, PA 18240 Phone: [phone] Fax: [phone]
Website
: www.hydra-tech.com E-Mail: [e-mail]
WEIGHT: ............................................... 17 lbs. (8 kg)
HEIGHT:............................................. 15 1/2" (39 cm)
DIAMETER:....................................... 5 5/16" (14 cm)
DISCHARGE:.................................... 1 1/2 ", NPT(F)
SOLIDS HANDLING:................................1/4" (7 mm)
HOSE PORTS:...................................... 3/8" NPT (F)
PUMP BODY:............................. Anodized Aluminum
IMPELLER:........................................ Stainless Steel
SUCTION CASE: ................................. Rubber Lined
SHAFT:............................................... Stainless Steel
SHAFT SEAL:................................ Carbon / Ceramic
ELASTOMERS:..................................... Buna N (Std)
HYDRAULIC OIL:..... 214-320 s.s.u. @ 100°F (64°C)
INPUT FLOW:........................ Max 7 GPM (26 LPM)
OPERATING PRESSURE:. Max 2000 PSI (136 Bar)
POWER SOURCE:..
Any Open Center Hydraulic System
SPECIFICATIONS
Specifications are subject to change without notice